ODYZYME CBR

Water present in cooling system, cooling towers etc …, form a favorable environment for the development of micro-organisms (bacteria, algae and fungus).

In fact, all the necessary factors for rapid development of micro-organisms are pre-sent (at different degrees) :
– Natural light,

– Oxygen (mixing),
– Nutrients (air-scrubbers), – Water temperature

(often between 20°C and 30°C),

– Etc …

The extremely rapid proliferation of living organic matter results in the appearance of sludge, deposit which disturbs the good working order of the installations (motor overheating, decreasing of thermal performance).

Moreover, the presence of micro-organisms is often responsible for localized corrosion under deposit (production by their metabolism of corrosive products., …).

Among bacteria, the most virulent and the most supervised is the legionella pneumophila. In fact, the inhalation of micro-droplets of water contaminated by these bacteria can cause legionellosis to mankind.

We know that biofilm provides good protection for bacteria against any form of aggression, and excessive biocide injections have not always been successful.

If we want to totally eliminate the legionella pneumophila, it is necessary to completely remove the biofilm.

It is also a simple and effective solution for fighting the growth of mollusks in your makeup water systems, source of common problem in direct refrigeration equipment that uses seawater and/or freshwater as makeup.

To help respect these objectives we recommend the usage our solution.

Contains an organic corrosion inhibitor.

A single solution, injected discontinuously in the form of a curative or preventive shock depending on the objective.

Respect the standards of rejection if used at recommended quantity.

Eliminates the biofilm easily.

It’s a cleaning product, It will be injected upstream from the system in shock dose of : 10 to 40 g/m3 (basic dosage).

For a complete elimination of the biofilm : a contact time of 3 hours in doses prescribed below is necessary.
Dosing : 60 to 100 ppm.

For Cooling tower application : It can be injected proportionate to the makeup water, between 10/N and 40/N.
N is the permissible rate of concentration in the cooling tower network.

For a mollusks growth limitation :
Dosing : 3 to 20 ppm, for 10 to 60 minutes every 8 to 24 hours.

Its efficiency depends on the contact time and the quality of the treated water.

Function of the application, it can be used as a supplement to antiscaling / biocide treatment.

its use allows to reduce considerably doses of biocide while keeping effectiveness and assuring the safety of system. It significantly reduces the environmental impact of biocides.

The injection point of the product should be chosen in such a way to avoid :
– Stagnation of product after injection,
– Preferential ways,

It is recommended to take customary precautions while handling chemicals (gloves, glasses …).
Consult the Safety Data Sheet (SDS).

The products must be kept away from frost.

it is available in 20, 210 and 800 kg, non returnable plastic drums.

For any other packaging please contact us.

Note : Do not mix the undiluted product with other chemical compounds without consulting us first.

The information and recommendations contained in this instruction manual are based upon our joint work with our customers and our current knowledge. They are provided merely as an indication and do not constitute an obligation of result. Date : 30/11/2021.